Ribonucleotide reductase (RR)

On L1210 and L1210/HUr cells, 3-AP exhibits anti-proliferative action with IC50 values of 1.3 and 1.6 µM, respectively [1]. When 3-AP (5, 10, 15, 20, 30 mg/kg; intraperitoneally; twice daily for six days) was given, as well as in long-term survivors, significant increases in lifespan were noted [1].

The enzyme RR catalyzes the conversion of ribonucleoside diphosphates to their deoxyribonucleotide counterparts. RR is critical for the generation of the cytosine, adenine, and guanine deoxyribonucleotide 5'-triphosphate building blocks of DNA, which are present in cells as exceedingly small intracellular pools. Therefore, interference with the function of RR might well result in an agent with significant antineoplastic activity, particularly against rapidly proliferating tumor cells. HUr is the only inhibitor of RR in clinical usage; this agent, however, is a relatively poor inhibitor of the enzyme and has a short serum half-life. Consequently, HUr is a relatively weak anticancer agent. In an effort to develop a more potent inhibitor of RR with utility as an anticancer agent, we have synthesized 3-AP and demonstrated (a) potent inhibition of L1210 leukemia cells in vitro, (b) curative capacity for mice bearing the L1210 leukemia, (c) marked inhibition of RR, and (d) sensitivity of HUr-resistant cells to 3-AP. These findings collectively demonstrate the clinical potential of 3-AP as an antineoplastic agent[1].

α-N-Heterocyclic thiosemicarbazones are an important class of investigational anticancer drugs. The most prominent representative is 3-aminopyridine-2-carboxaldehyde thiosemicarbazone (Triapine), which has shown promising results in clinical trials and is currently evaluated in phase III. In this study, we investigated the influence of a chalcogen atom exchange from S (Triapine) to O (O-Triapine) and Se (Se-Triapine) and the methylation of the hydrazonic NH moiety (Me-Triapine) on their complexation with Fe(ii), Fe(iii) and Cu(ii) ions and their cytotoxicity. The main aim of this study was to characterize and compare the most feasible chemical forms in solution, their stability and redox properties, as well as to reveal the relationships of the solution speciation and kinetic data with cytotoxic activity. The complex equilibria and redox properties of the complexes were characterized by the combined use of pH-potentiometry, UV-visible spectrophotometry, electron paramagnetic resonance spectroscopy, and cyclic voltammetry. These revealed that Se-Triapine forms Cu(ii) complexes with higher, and O-Triapine with lower stability as compared with Triapine. Me-Triapine, which is not able to coordinate via the typical (N,N,S-) donor set, nevertheless coordinates to Cu(ii) with unexpected high stability. The Cu(ii) complexes of Se-Triapine and Me-Triapine can be relatively slowly reduced by glutathione at pH 7.4 (but not by ascorbate), similarly to Cu(ii)-Triapine. In contrast, the Cu(ii)-O-Triapine complex can be reduced by both reducing agents in rapid redox reactions. Se-Triapine and Triapine form high stability complexes with both Fe(ii) and Fe(iii) ions, while O-Triapine has a much stronger preference towards Fe(iii) and Me-Triapine towards Fe(ii). This difference in the iron preference of the ligands seems to have a strong impact on their cytotoxic effects, which was measured in a human uterine sarcoma cell line (MES-SA) and its multidrug-resistant subline (MES-SA/Dx5). The Cu(ii) complexes of these calcogensemicarbazones are moderately toxic, and the highest level of ROS generation was found for the Cu(ii) complex of O-Triapine, which is the most reducible[2].

[1]. Triapine (3-aminopyridine-2-carboxaldehyde thiosemicarbazone; 3-AP): an inhibitor of ribonucleotide reductase with antineoplastic activity. Adv Enzyme Regul. 1999;39:3-12.

[2]. Complex formation and cytotoxicity of Triapine derivatives: a comparative solution study on the effect of the chalcogen atom and NH-methylation. Dalton Trans. 2020 Dec 8;49(46):16887-16902.

Triprine is a synthetic heterocyclic formaldehyde-thioaminourea compound with potential antitumor activity. Triprine inhibits ribonucleotide reductase, thereby inhibiting the conversion of ribonucleoside diphosphate into deoxyribonucleotides essential for DNA synthesis. In vitro experiments have shown that this drug can inhibit tumor growth. Triprine has been used in clinical trials for the treatment of various cancers, including leukemia, lung cancer, kidney cancer, prostate cancer, and pancreatic cancer. (NCI04)

C7H9N5S

195.24486

195.057

C, 43.06; H, 4.65; N, 35.87; S, 16.42

200933-27-3

Triapine;143621-35-6

9571836

Light yellow to khaki solid powder

1.46

436.0±55.0 °C at 760 mmHg

217.5±31.5 °C

0.0±1.0 mmHg at 25°C

1.720

0.98

3

4

2

13

205

0

NC(N/N=C/C1=C(N)C=CC=N1)=S

XMYKNCNAZKMVQN-NYYWCZLTSA-N

InChI=1S/C7H9N5S/c8-5-2-1-3-10-6(5)4-11-12-7(9)13/h1-4H,8H2,(H3,9,12,13)/b11-4+

[(E)-(3-aminopyridin-2-yl)methylideneamino]thiourea

Triapine; 3-AP; 236392-56-6; 143621-35-6; 200933-27-3; OCX 191; 2-((3-Aminopyridin-2-yl)methylene)hydrazinecarbothioamide; PAN-811;

2934.99.9001

Powder      -20°C    3 years

                     4°C     2 years

In solvent   -80°C    6 months

                  -20°C    1 month

Room temperature (This product is stable at ambient temperature for a few days during ordinary shipping and time spent in Customs)

May dissolve in DMSO (in most cases), if not, try other solvents such as H2O, Ethanol, or DMF with a minute amount of products to avoid loss of samples

Note: Listed below are some common formulations that may be used to formulate products with low water solubility (e.g. < 1 mg/mL), you may test these formulations using a minute amount of products to avoid loss of samples.

---

Injection Formulation 1: DMSO : Tween 80： Saline = 10 : 5 : 85 (i.e. 100 μL DMSO stock solution → 50 μL Tween 80 → 850 μL Saline)
*Preparation of saline: Dissolve 0.9 g of sodium chloride in 100 mL ddH ₂ O to obtain a clear solution.
Injection Formulation 2: DMSO : PEG300 ：Tween 80 : Saline = 10 : 40 : 5 : 45 (i.e. 100 μL DMSO → 400 μLPEG300 → 50 μL Tween 80 → 450 μL Saline)
Injection Formulation 3: DMSO : Corn oil = 10 : 90 (i.e. 100 μL DMSO → 900 μL Corn oil)
Example: Take the Injection Formulation 3 (DMSO : Corn oil = 10 : 90) as an example, if 1 mL of 2.5 mg/mL working solution is to be prepared, you can take 100 μL 25 mg/mL DMSO stock solution and add to 900 μL corn oil, mix well to obtain a clear or suspension solution (2.5 mg/mL, ready for use in animals).

View More

Injection Formulation 4: DMSO : 20% SBE-β-CD in saline = 10 : 90 [i.e. 100 μL DMSO → 900 μL (20% SBE-β-CD in saline)]
*Preparation of 20% SBE-β-CD in Saline (4°C，1 week): Dissolve 2 g SBE-β-CD in 10 mL saline to obtain a clear solution.
Injection Formulation 5: 2-Hydroxypropyl-β-cyclodextrin : Saline = 50 : 50 (i.e. 500 μL 2-Hydroxypropyl-β-cyclodextrin → 500 μL Saline)
Injection Formulation 6: DMSO : PEG300 : castor oil : Saline = 5 : 10 : 20 : 65 (i.e. 50 μL DMSO → 100 μLPEG300 → 200 μL castor oil → 650 μL Saline)
Injection Formulation 7: Ethanol : Cremophor : Saline = 10： 10 : 80 (i.e. 100 μL Ethanol → 100 μL Cremophor → 800 μL Saline)
Injection Formulation 8: Dissolve in Cremophor/Ethanol (50 : 50), then diluted by Saline
Injection Formulation 9: EtOH : Corn oil = 10 : 90 (i.e. 100 μL EtOH → 900 μL Corn oil)
Injection Formulation 10: EtOH : PEG300：Tween 80 : Saline = 10 : 40 : 5 : 45 (i.e. 100 μL EtOH → 400 μLPEG300 → 50 μL Tween 80 → 450 μL Saline)

---

Oral Formulation 1: Suspend in 0.5% CMC Na (carboxymethylcellulose sodium)
Oral Formulation 2: Suspend in 0.5% Carboxymethyl cellulose
Example: Take the Oral Formulation 1 (Suspend in 0.5% CMC Na) as an example, if 100 mL of 2.5 mg/mL working solution is to be prepared, you can first prepare 0.5% CMC Na solution by measuring 0.5 g CMC Na and dissolve it in 100 mL ddH2O to obtain a clear solution; then add 250 mg of the product to 100 mL 0.5% CMC Na solution, to make the suspension solution (2.5 mg/mL, ready for use in animals).

View More

Oral Formulation 3: Dissolved in PEG400
Oral Formulation 4: Suspend in 0.2% Carboxymethyl cellulose
Oral Formulation 5: Dissolve in 0.25% Tween 80 and 0.5% Carboxymethyl cellulose
Oral Formulation 6: Mixing with food powders

---

Note: Please be aware that the above formulations are for reference only. InvivoChem strongly recommends customers to read literature methods/protocols carefully before determining which formulation you should use for in vivo studies, as different compounds have different solubility properties and have to be formulated differently.

---

 (Please use freshly prepared in vivo formulations for optimal results.)